Category Archives: General
Cisco with EHWIC-3G-HSPA+7 card configuration
A good site for Wiki-Cisco Linux information with regards to 3G Connections and Cisco Routers.
Megawatt Batteries
The x2 new Megawatt batteries installed at the Mungullah Power Station – Carnarvon 👍🏼⚡️
SensorIQ: https://www.silverspringnet.com/wp-content/uploads/Sensor_IQ3.0_Datasheet_2017.pdf
Check Signal Strength On Your iPhone
Launch the Phone app Dial *3001#12345#* Then tap on the Call button, which will launch the Field Test app (or enter the field test mode). You’ll also notice that the signal strength indicator has switched to a number from the traditional signal bar. Now hold the Power button until the red slider (slide to powerContinue reading “Check Signal Strength On Your iPhone”
Extend your ring time on your Telstra mobile
Extend your ring time By default your phone rings for 15 seconds before diverting a call. To extend the ring time, enter the following sequence on your phone, followed by the number of seconds you wish your phone to ring for, then hash. Press **61*101**[15, 20, 25 or 30]#. Press the call/send button. For example, to make the phone ringContinue reading “Extend your ring time on your Telstra mobile”
Central Manager Alarms
Description: Central Manager’s secure store is initialized but not opened. Fix: Secure Shell to the device (C.M.) and open the store by using ‘cms secure-store open’ from the CLI, and enter the password. WAAS Alarm Book
Nvidia GeForce GTX 1080 review :)
Configuring Nexus vPC – Part 1
My favorite command in all of NX-OS – no feature vpc Kidding! It’s actually not that bad once you’re aware of how it works, what are the caveats, and how to troubleshoot if you ru… Source: Configuring Nexus vPC – Part 1
Creating a SPAN session on a Nexus 9K
Create SPAN session ================================= 9kswitch# conf t 9kswitch(config)# monitor session 1 Configure destination port (destination cannot be a FEX port or a Port-channel!) ================================= 9kswitch# conf t 9kswitch(config)# interface eth 1/15 9kswitch(config-if)# switchport monitor 9kswitch(config-if)# exit 9kswitch(config)# monitor session 1 9kswitch(config-monitor)# destination interface eth 1/15 Configure source port (or VLAN) ================================= 9kswitch(config-monitor)# source interface ethContinue reading “Creating a SPAN session on a Nexus 9K”
MystaJoneS 