Category: Cisco
-
+
+
+
+
+
+
Reference Material vWAAS Install Guide Wave 694 Installation Guide WAAS Wiki WAAS Configuration Guide Deploying WAAS
-
+
+
+
+
+
+
OK, this wasn’t quite as simple as i would have first thought but I got there in the end. The version of Prime I was initially running was 2.0.0.0.39 and had to be upgraded before I could do a backup that would be compatible with 2.2. I upgraded 2.0.0.0.39 >> version 2.1 by…
-
+
+
+
+
+
+
Useful documentation on OEAP
-
+
+
+
+
+
+
Project ‘Upgrade Cisco Prime’, requires i backup the Database using the below commands. Cisco Prime Infrastructure 2.2 Admin Guide Step 1 Open a CLI session with the Prime Infrastructure server (see Connecting Via CLI). Step 2 Enter configuration mode: PIServer/admin# configure terminal Step 3 Configure a symbolic link to the remote…
-
+
+
+
+
+
+
prime-infrastructure-update-october-2014
-
+
+
+
+
+
+
I’m looking forward to setting up a Nexus 9k Solution, L3 using VXLAN BGP EVPN Topology Dual DataCentre configuration. Aiming for a Live/Live Core between the two. Only caveat is we will stick to L2 supporting the Edge, for Internet and IPWAN connections using traditional technologies such as HSRP. VXLAN BGP EVPN…..Configuration guide
-
+
+
+
+
+
+
You can also configure eBGP using a loopback address (or any other operational interface) as shown in this section. Loopback interfaces are used in this manner to guarantee reachability in networks with multiple paths as shown in the Load Sharing Using the Loopback Address as a BGP Neighbor section of Load…
-
+
+
+
+
+
+
In this configuration, the router owen is in AS 300 and Router jazz is in AS 400. Peers must be directly connected when using eBGP. If they are not directly connected, the neighbor ebgp-multihop command must be used and a path through an IGP or static route to reach the peer…
-
+
+
+
+
+
+
In this configuration, both routers are in AS 400.
MystaJoneS 